<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META http-equiv=Content-Type content="text/html; charset=US-ASCII">
<META content="MSHTML 6.00.6000.16640" name=GENERATOR></HEAD>
<BODY id=role_body style="FONT-SIZE: 10pt; COLOR: #000000; FONT-FAMILY: Arial"
bottomMargin=7 leftMargin=7 topMargin=7 rightMargin=7><FONT id=role_document
face=Arial color=#000000 size=2>
<DIV>We had this on a 5 by 7 card that was taped inside the door below the
monitor on the sidecar. It worked and we had very few
problems. Thought that I would pass it on.</DIV>
<DIV> </DIV>
<DIV>Chris Hill</DIV>
<DIV> </DIV>
<DIV> </DIV>
<DIV> </DIV>
<DIV>VR-1200 B Series Inter-Sync Systems Daily Set Up</DIV>
<DIV> </DIV>
<DIV>PRIOR TO ANY ADJUSTMENT, LET HEAD SPIN FOR ABOUT 30 MINUTES</DIV>
<DIV> </DIV>
<DIV>Do in the following order</DIV>
<DIV> </DIV>
<DIV>Reference Discriminator<BR> With head spinning, adjust R28 on board 2
for zero.</DIV>
<DIV> </DIV>
<DIV>Drum Oscillator</DIV>
<DIV> </DIV>
<DIV> With head stopped, adjust Drum oscillator R21 on board 6 for stable
wave form.</DIV>
<DIV> </DIV>
<DIV>Tach Discriminator</DIV>
<DIV> </DIV>
<DIV> With Drum spinning, set R85 on board 6 for zero</DIV>
<DIV> </DIV>
<DIV>Capstan Oscillator<BR> <BR> Set Capstan Oscillator for steady
wave form</DIV>
<DIV> </DIV>
<DIV>Capstan Discriminator</DIV>
<DIV> </DIV>
<DIV> With Machine in Record, set R1 on board 12 for zero</DIV>
<DIV> </DIV>
<DIV>Drum Tach position</DIV>
<DIV> </DIV>
<DIV> With Machine in Record, verify that tach is at correct position on
demod using pulse cross.</DIV>
<DIV> </DIV>
<DIV><BR>If doing editing,</DIV>
<DIV> </DIV>
<DIV>Turn Editor on</DIV>
<DIV> </DIV>
<DIV> Set H Phase to zero with input that you are using when source is
timed</DIV>
<DIV> </DIV>
<DIV> Set Tach Phase to same position as was used in RECORD mode</DIV>
<DIV> </DIV>
<DIV> Note: If original tape was as recorded with incorrect Tach phase, set
Tach phase to match the incorrect tape. </DIV>
<DIV> </DIV>
<DIV>H phase sets quality of in-going edit and Tach Phase sets quality of out
going edit. Do a test edit if desired and check AMTEC error for quality of
edits.</DIV></FONT><DIV CLASS="aol_ad_footer" ID="5d8076ef98603873ce69becee8cb298"><br/><font style="color:black;font:normal 10pt arial,san-serif;"> <hr style="margin-top:10px"/></font></DIV></BODY></HTML>